5.Change Measurement Mode
◆ Default setting of measurement is Single Measurement Mode, indication is shown as figure I.
Short-time press
◆ Short-time press
figure K. Short-time press
Mode, indication is shown as figure L.
◆ Short-time press
indication is shown as figure M.
◆ Short-time press
will be displayed, indication is shown as figure N.
◆ (Note: In the Historical Data Review Mode, there will be some measuring data that factory
tested. It does not mean this equipment has been used.)
to switch Area Measurement Mode, indication is shown as figure J.
again to switch Volume Measurement Mode, indication is shown as
again to switch Single Pythagorean Theorem Measurement
again to switch Dual Pythagorean Theorem Measurement Mode,
again to switch Historical Data Review Mode, the last measuring data
6