Table of Contents
Advertisement
time press
to close the laser point, indication as shown as figure B. Short-time press
again to open laser point, indication as shown as figure C.
3.Change Reference Edge
Default reference edge is the bottom of meter, indication is shown as figure D. Long-time press
to change the measuring reference to the top of meter, indication as shown as figure E.
4.Unit Conversion
⚫
Factory default that unit is m, indication is shown as figure F. Long-time press
switch unit m to Ft, indication as shown as figure G.
⚫
Long-time press
(Note: Long-time press
correspondent at the same time if there is value of measurement.)
⚫
When the unit is m2, Long-time press
⚫
When the unit is m3, Long-time press
⚫
When you switch on meter later, the meter will remember the last measuring unit you used.
again to switch the unit Ft to In, indication is shown as figure H.
to switch the unit of measurement, the value will switch
, the unit will switch unit m2 to Ft2.
, the unit will switch unit m3 to Ft3.
5
to
Advertisement
Table of Contents
