Lubrication; Caster Wheel Lubrication; Cable Lubrication; Changing Engine Oil - Generac Power Systems Powerwagon Owner's Manual

Lubrication

Caster Wheel Lubrication

See Figure 4-1. Grease the four fittings (A) with #2 lith-
ium grease every 25 hours of operation.
Figure 4-1. Caster Wheel Lubrication Locations

Cable Lubrication

See Figure 4-2 and Figure
at handlebars and control panel using SAE 30 oil. Oper-
ate levers to work lubricant into cables.
B
Figure 4-2. Cable Lubrication Locations
Figure 4-3. Cable Connection Lubrication Locations
Owner's Manual for Powerwagon
A
006177
4-3. Lubricate cable ends (B)
B
006178
006179
B
Maintenance and Troubleshooting

Changing Engine Oil

WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
WARNING
Skin irritation. Avoid prolonged or repeated contact with
used motor oil. Used motor oil has been shown to cause
skin cancer in laboratory animals. Thoroughly wash
exposed areas with soap and water.
CAUTION
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
NOTE: Drain oil when engine is warm. Warm oil drains
more completely.
1. Lift bed to upright position.
2. Remove oil dipstick/fill cap and wipe off with a
clean rag.
3. Install oil dipstick/fill cap and screw in. Remove oil
dipstick/fill cap and inspect oil level.
4. Insert oil pump and remove old oil. Remove oil
pump.
5. Add fresh oil. See Engine Fluid
6. Install oil dipstick/fill cap and hand tighten.
7. Dispose of used engine oil in accordance with
local, state, or national laws.
(000139)
(000210)
(000135)
Requirements.
21