Slopes And Uneven Terrain; Unloading Bed; Operating Tips - Generac Power Systems Powerwagon Owner's Manual

Table of Contents

Advertisement

Slopes and Uneven Terrain

WARNING
Personal injury. Use caution when operating unit over
uneven terrain or slopes. Failure to do so could result
in death, serious injury, equipment or property
damage.
WARNING
Loss of control. Do not park the unit on a steep grade
or slope, even if using a parking brake. The unit could
suddenly roll, move, or tip, which could cause death,
serious injury, property or equipment damage.
WARNING
Loss of control. Always drive up and down a slope.
Never drive on slopes greater than 15 degrees. Failure
to do so could result in death, serious injury, property
or equipment damage.
WARNING
Loss of control. Operate in first gear when driving
on slopes. Failure to do so could result in serious
injury, property or equipment damage.
WARNING
Personal injury. Never shift gears while operating on a slope.
Doing so could result in loss of control and could cause
death, serious injury, or property or equipment damage.
WARNING
Tipping hazard. Do not overload unit. Do not transport
top-heavy loads. Load only to rated weight. Distribute load
evenly and secure properly. Improper loading could cause
death, serious injury, or equipment damage.
WARNING
Personal injury. Do not operate unit from outside the
operator zone. Doing so could result in death, serious
injury, or equipment damage.
Owner's Manual for Powerwagon

Unloading Bed

IMPORTANT NOTE: Never dump load while on a
slope.
1. Shift to neutral and set parking brake.
2. Remove tailgate.
3. Turn key to run.
(000460)
4. Hold electric dump switch in the upper DUMP posi-
tion to raise bed to empty it.
5. Hold power dump switch down in the lower FLAT
position to lower bed once dumping is complete.

Operating Tips

(000498)
Electric dump system allows loose materials to be
distributed over an area rather than in a concen-
trated pile. Move unit in reverse with bed partially
tipped to spread load.
Electric dump system allows bed to be stopped at
any point in the tipping range.
(000499)
(000500)
(000414)
(000495)
(000440)
Operation
17

Advertisement

Table of Contents
loading

Table of Contents