Edic ENDEAVOR 9000I-HSH Owner's/Operator's Manual page 17

spray gun.
4. Fill the machine with water. See page 10 for auto fill
instructions.
5. Prime the pump as per instructions on page 9.
6. Adjust the pressure to 500psi. See instructions on
page 9.
7. Chemical will draw only in the "LOW" pressure
setting of your pressure gun. To activate the "LOW"
pressure setting, pop the collar of the gun out.
8. In "LOW" pressure, apply chemical to the walls and
fixtures starting from the lowest point to the highest.
9. Spray the floor as you make your way out of the
room.
10. Allow the chemical time to dwell according to the
chemical manufacturers recommendations.
11. You may use a brush to agitate particularly soiled
areas.
12. When you are ready to rinse away the chemical,
pull the collar of your 9000AC "IN", to activate high
pressure rinse mode. If you require a higher volume
of flow for rinse mode, you may bypass the 991RS
chemical injector system by connecting your 25ft
hose directly to the male quick connect on the EN-
DEAVOR's control panel.
13. Rinse surfaces starting from the top and working
your way down.
14. Use a 334ACH squeegee wand to extract the excess
fluid from the floor.
16