RAKwireless RAK7200 Get Started page 4

v2.0.0.0.0
1. Hold down the BOOT0 button, then press the Reset button;
2. Loosen the Reset button, then Loosen the BOOT0 button.
Open the "STM32CubeProgrammer" tool, and select UART type, then configure the
Port, Baudrate, and Pairty as the following picture shows:
Note: It is COM5 on my computer, and it may be another COM port on your computer.
Then press "Connect" button at the top right corner. If there are some errors in the Log
box as follow:
4