Accessories; Trasportation And Storage; Job Suggestion - KNOVA KN INW-130 Manual

ACCESSORIES

No. Description
1 MMA Welder
2 Operator's Manual
3 Electrode Holder
4 Earth Clamp
5 Face Mask with Filter
6 Brush & Hammer
NOTES: All above mentioned are based on the ordering
contact unless otherwise agreed by the parties.
TRANSPORTATION AND STORAGE
• This machine is an indoor equipment and the attacks of
rain and snow should be avoided in the process of
transportation and storage. While loading and unloading,
more attention should be paid on the package with words
of warning. Storage warehouse should be kept dry with
good air circulation and no corrosive gas or dust.
The temperature should be maintained from
-25º C to 55º C and relative humidity must be lower than
90%.

JOB SUGGESTION

Amperage ratio according to electrode diameter
(Approximate value)
min max
32 40
50 60
62 75
96 128
120 160
200 250
256 320
Note: The table is only informative, it does not mean that
the equipment can operate all the listed electrodes
and diameters, only those that the amperage and duty
cycles allow.
Qty.
1 set
1 pc
1 pc
1 pc
1 pc
1 pc
ROD DIAMETER
1.6 mm 1/16"
2.0 mm 5/64"
2.5 mm 3/32"
3.2 mm 1/8"
4.0 mm 5/32"
5.0 mm 3/16"
6.4 mm 1/4"
• If the products are still needed to continue storing after
stripping, repacking should be carried out according to
original package's requirement. Remember before
storage, don't forget to clean and seal it with plastic
bags.
• Users should maintain the cartons and shock blocks in
order to be properly packaged in need of long distant
transportation. For the long distant transportation, it
should be retrofitted with a wooden case and mark
the "up" or "rain" symbols.
7