Interconnection Diagram; Accessories; Job Suggestion - KNOVA KN INW-160 Manual

INTERCONNECTION DIAGRAM

ECN Soldering Iron
Circuit Schematic
(Reference figures
are subject to change
without notice).

ACCESSORIES

No. Description
1 Welder
2 Operator's Manual
3 Electrode Holder
NOTES: All above mentioned are based on the ordering contact unless otherwise agreed by the parties.
TRANSPORTATION AND STORAGE
• This machine is an indoor equipment and the attacks of
rain and snow should be avoided in the process of
transportation and storage. While loading and unloading,
more attention should be paid on the package with words
of warning. Storage warehouse should be kept dry with
good air circulation and no corrosive gas or dust.
The temperature should be maintained from -25º C to 55º C
and relative humidity must be lower than 90%.

JOB SUGGESTION

Amperage ratio according to electrode diameter
(Approximate value)
min max
32 40
50 60
62 75
96 128
Qty.
1 set
1 pc
1 pc
ROD DIAMETER
1.6 mm 1/16"
2.0 mm 5/64"
2.5 mm 3/32"
3.2 mm 1/8"
No.
4 Earth Clamp
5 Face Mask with Filter
6 Brush & Hammer
• If the products are still needed to continue storing after
stripping, repacking should be carried out according to
original package's requirement. Remember before storage,
don't forget to clean and seal it with plastic bags.
• Users should maintain the cartons and shock blocks in order
to be properly packaged in need of long distant transportation.
For the long distant transportation, it should be retrofitted
with a wooden case and mark the "up" or "rain" symbols.
min max
120 160
200 250
256 320
Note: The table is only informative, it does not mean that the
equipment can operate all the listed electrodes and diameters,
only those that the amperage and duty cycles allow.
7
Description
ROD DIAMETER
4.0 mm
5.0 mm
6.4 mm
Qty.
1 pc
1 pc
1 pc
5/32"
3/16"
1/4"