Connecting The Switch To The Network; Setting Up The Management Interface; Uplink Connections - Cisco Nexus 93120TX Installation Manual

Connecting the Switch to the Network

•
•
•
•
•

Setting Up the Management Interface

The management port (MGMT ETH) provides out-of-band management, which enables you to use the
command-line interface (CLI) to manage the switch by its IP address. This port uses a 10/100/1000 Ethernet
connection with an RJ-45 interface.
Before You Begin
The switch must be powered on.
Step 1 Connect a modular, RJ-45, UTP cable to the MGMT ETH port on the switch.
Step 2
Connect the other end of the cable to a 10/100/1000 Ethernet port on a network device.
What to Do Next
You are ready to connect the interface ports on each of the I/O modules to the network.

Uplink Connections

The switch has an uplink module with 12 or six 40-Gigabit optical ports or four 100-Gigabit optical ports.
For a list of transceivers and cables by this switch for uplink connections, see
support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Setting Up the Management Interface, page 31
Uplink Connections, page 31
Downlink Connections, page 32
Guidelines for Connecting Ports, page 32
Maintaining Transceivers and Optical Cables, page 33
C H A P T E R
Cisco Nexus 93120TX NX-OS Mode Switch Hardware Installation Guide
4
http://www.cisco.com/c/en/us/
31