Cisco Nexus 93120TX Installation Manual page 12

Overview
The following figure shows the hardware features seen from the port side of the chassis.
Figure 1: Hardware Features on the Port Side of the Chassis
1 96 10GBASE-T copper ports (supporting speeds
of 100 Megabits, 1 Gigabit, and 10 Gigabits) to
other devices
2 6 40-Gigabit Ethernet Quad Small Form-Factor
Plugable (QSFP+) optical ports for uplink
connections to aggregation switches
3 Out-of-band management port (RJ-45 port)
4 Console port (RS232 port)
5 Two USB ports used for saving or copying
functions
Note
To determine which transceivers, adapters, and cables are supported by this switch, see the Cisco Nexus 9000
Series (Fixed 9300) at
products-device-support-tables-list.html.
Cisco Nexus 93120TX NX-OS Mode Switch Hardware Installation Guide
2
USB support is limited to USB 2.0
devices that use less than 2.5 W (less
than 0.5 A inclusive of surge current).
Devices, such as external hard drives,
that instantaneously draw more than 0.5
A are not supported.
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/
6 Chassis LEDs
• Beacon (BCN)
• Status (STS)
• Environment (ENV)
7 Screw holes (2) for attaching a front-mount
bracket for four-post racks (one bracket on each
of two sides)
8 Screw holes (4) for attaching a center-mount rack
bracket for two-post racks (one bracket for each
of two sides)
9 Notch in both sides of the chassis for locking the
power supply end of the chassis to the
bottom-support rails
Overview