Canon PD-82K Service Manual page 71

Action: Reconnect the registration clutch connector J306, intermediate connector J210,
and connector J207 on the paper deck driver PCB.
9. Registration clutch failure
Action: Disconnect the registration clutch connector J306. Measure the resistance between
the connector J306-1 (/REGCLD) and J306-2 (+24V) of the cable. Replace the reg-
istration clutch if the resistance is not about xx Ohm.
10. The paper jam sensor lever is damaged/deformed or the spring is out of place.
Action: Replace the paper jam sensor lever if damaged or deformed. If the sensor lever
spring is out of place, set it in the right position.
11. Paper jam sensor failure
Action: Replace the paper jam sensor.
12. Worn/deformed/dirty feed roller 2
Action: Clean the feed roller 2 if dirty. Replace the roller if worn or deformed.
13. Paper deck driver PCB
Action: Replace the paper deck driver PCB.
CHAPTER 4
4 - 11