Tail Lamps - BMW 2008 M6 Owner's Manual

procedures with correspondingly trained per-
sonnel. Due to the high voltage involved, there
is a danger to life and limb when work is carried
out improperly.<
Parking lamps, roadside parking
lamps, daytime running lamps
The illustration shows the front left side of the
engine compartment.
35-watt bulb, H 8
1. Remove the cover cap 1 by pressing the tab
and removing the cover cap upward.
2. Turn the bulb holder to the left and remove.
3. Remove and replace the bulb.
Always wear gloves and eye protection –
the atmosphere inside the H8 bulb is
pressurized. Otherwise, there is a danger of
injuries if the bulb is accidentally damaged dur-
ing replacement.<
Side-mounted turn signals
5-watt bulb, WY5W
1. Press against the front edge of the lamp
with the tip of your finger, then push it to the
rear, release the snap connection at the
front and take it off the trim strip.
Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG
2. Turn the bulb holder to the left by 90 5 and
remove.
3. Remove and replace the bulb.

Tail lamps

The parking lamps, tail lamps, brake
lamps, and turn signals use LED technol-
ogy. The backup lamps are equipped with long-
life bulbs. Please contact a BMW center in case
of a malfunction.<
1 Turn signals
2 Roadside parking, tail and brake lamp
3 Reflector
4
Backup lamp
License plate lamps
5-watt bulb, W5W
1. Push a screwdriver from the left under the
lamp and pry out the lamp toward the right.
2. Turn the bulb holder to the left by 90 5 and
remove.
3. Remove and replace the bulb.
217