Subscribe to Our Youtube Channel
Related Manuals for Etic Telecom XSRACK
Summary of Contents for Etic Telecom XSRACK
- Page 1 XSRACK Switch SHDSL _________________ USER GUIDE _________________ DOC_DEV_XSRACK_User guide_A...
- Page 2 The product family XSRACK is designed and manufactured by ETIC TELECOM 13 Chemin du vieux chêne 38240 MEYLAN FRANCE TEL : + (33) (0)4-76-04-20-05 E-mail : hotline@etictelecom.com web : www.etictelecom.com Page 2 DOC_DEV_XSRACK_User guide_A...
- Page 3 DECLARATION OF CONFORMITY The manufacturer, ETIC Telecom – 13 chemin du vieux chêne – 38240 Meylan – France, Hereby declares under sole responsibility that the listed products conform to the Electromagnetic Compatibility (EMC) Directive 2014/30/UE , the Low Voltage Directive (LVD) 2014/35/UE , the Restriction of the use of certain Hazardous Substances (RoHS) Directive 2011/65/UE.
-
Page 5: Table Of Contents
Crosstalk interference ......................... 17 Shield earthing ............................. 17 Protecting the SHDSL switch from lightning ..................18 Connecting the XSRACK to the line ....................... 18 General precautions ..........................18 Point to point connection using two, three or four twisted pairs ............18 PREPARING THE SETUP ...................... -
Page 7: Overview
Purpose of this manual The present user guide describes the features and the installation of the SHDSL switch XSRACK-1260. In the rest of the document the term " XSRACK " is also used to designate the product. Specifications General characteristics... - Page 8 PRESENTATION ETHERNET & IP Ethernet 6 ports - 10/100 Mb/s Half/Full duplex Auto MDI/MDIX Switch Store and forward - 1024 MAC addresses Redundancy RSTP - IEEE 802.1D / 802.1Q VLAN IEEE 802.1Q IPV4 et IPV6 IP address Multicast and broadcast filtering IP router Static routes RIP V2...
-
Page 9: Emc & Environment Compliances
OVERVIEW EMC & Environment compliances EMC Immunity, EN61000-6-2 Norme critère Port Level pass EN61000-4-2 +/-4kv contact Enclosure +/-8kv air discharge EN61000-4-3 Enclosure 10V/M AM @ 1khz 80Mhz to 3Ghz Radiated EN61000-4-4 SHDSL +/- 2kv Burst Power supply +/- 2kv Ethernet +/- 2kv EN61000-4-5 +/- 5kv common mode (Normal and Telecom... - Page 10 PRESENTATION Climatic Standard Testy Level EN 60068-2-1 -40 °C - 16 hours – Non-operating - TBD Cold -20 °C - 16 hours – Operating - TBD EN 60068-2-2 +85 °C - 16 hours – Non-operating - TBD Dry heat +55 °C - 16 hours – Operating - TBD EN 60068-2-14 -25 °C to +70 °C –...
-
Page 11: Product Overview
The data rate on each port is up to 5,7 Mb/s on 3,7 Km and 15 Mb/s on 0,7 Km (see table in Annex 1). Up to 12 XSLAN The XSRACK consists of 3 independent slots. Each slot provides 4 SHDSL ports and 2 Ethernet ports and has its own configuration and operation interface. The slots are not hot-swappable. - Page 12 PRESENTATION The XSRACK can interwork with any switch in the XSLAN family. For example, it is possible to connect one line to an XSLAN-1100 and another line to an XSLAN+2220. The XSRACK also offers advanced features. These functions are configured using a Web browser: •...
-
Page 13: Installation
INSTALLATION INSTALLATION Description Dimensions 435 mm 280 mm 44 mm 6 mm Front panel Slot 1 Slot 2 Slot 3 LED indicators SHDSL screw block Ethernet Rear panel Push-buttons Power connector 110–230 V Page 13 DOC_DEV_XSRACK_User guide_A... -
Page 14: Connectors
INSTALLATION Connectors 2 positions screw terminal: SHDSL Position Signal Function Line SHDSL line conductor Line SHDSL line conductor Ethernet RJ45 connector Position Signal Function RJ45 Tx + Emission polarity + Tx - Emission polarity - Rx + Reception polarity + Rx - Reception polarity - N.C. -
Page 15: Led Indicators
INSTALLATION LED indicators LED indicators Function Description Power 1 Steady green: The supply voltage 1 is present Power 2 Steady green: The supply voltage 2 is present Power off Steady green The unit is ready Slow blinking green The unit is busy Steady red Startup (30s) –... -
Page 16: Safety Instructions
30 °C. Installation dans une baie informatique The XSRACK is designed to be installed in a 19 inch computer bay. It can be placed on a tray or fixed using the mounting brackets provided. -
Page 17: Preparing And Checking The Line
Type of cable Twisted pair cable The XSRACK is designed to be connected to one or several telephone grade twisted pairs. The conductor diameter must be included between 0.4 mm and 1 mm. A cable may be composed of several twisted pairs. -
Page 18: Protecting The Shdsl Switch From Lightning
However, if the line is vulnerable to thunderstorms, for example if it is an air line, or if it is several kilometers long, or if the installation is in a very exposed area, it is recommended to protect each XSRACK with a surge protector connected to the earth. -
Page 19: Preparing The Setup
Connecting a PC for configuration Overview Each slot of an XSRACK is configured using a PC with an HTML browser. No additional software is required. Online help : For most pages of the administration server an help page is available by clicking located at the top right of the page. -
Page 20: First Configuration
Step 1 : Create or modify the PC TCP/IP connection Assign to the PC an IP address different but consistent with the factory IP address of the XSRACK slot For the first configuration, assign for instance 192.168.0.1 to the PC. -
Page 21: Temporary Return To The Factory Settings
Temporary return to the factory settings If the IP address of the XSRACK slot could not be founded, or if it is impossible to access the administration server, for example, following a bad VLAN configuration, it is possible to restore the factory settings without losing the current configuration. -
Page 22: Protecting The Access To The Administration Server
PREPARING THE SETUP Protecting the access to the administration server • In the menu, choose Setup > Security > Administration rights • Enter a user name and password to protect the administration server. • Tick the Password protect the web site access checkbox If the username and password to access the administration server are lost, you have to temporarily return to... -
Page 23: Annex 1 : Shdsl Data Rate Versus Distance
ANNEX 1 ANNEX 1 : SHDSL data rate versus distance The table below shows the data rate which is possible to get on a SHDSL link depending on the wire diameter and the distance. These values are indicative in noise free environment. Distance versus data rate through one pair Data rate 192Kb/s... - Page 24 13, Chemin du Vieux Chêne 38240 Meylan - France Tel : +33 (0)4 76 04 20 00 contact@etictelecom.com www.etictelecom.com...
Need help?
Do you have a question about the XSRACK and is the answer not in the manual?
Questions and answers