Samsung PS50C62HX/XEC Service Manual page 42

4-2-2 How to Access Service Mode
1. General Remote
POWER OFF
To Enter:
(Interval between key strokes: less than 3 sec)
POWER OFF
To Exit:
2. Factory Remote
To Enter: POWER ON
POWER OFF
To Exit:
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off)
4. Adjustment Procedures
- Channel ▲ ▼ Key : Select an item.
- Volume ◀▶ Key : Adjust the value up or down.
- MENU Key : Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
Panel ON time(Hour) 00002 L24E_RS
1. Calibration
2. Option Table (Service)
3. White Balance
4. MST68981
5. Option Block
6. Sound
T-LIL2PEUMD-XXXX
Month/ Day/ Year
Hour/ Min/ Sec
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
Samsung Electronics
INFO MENU
→ → →
POWER ON
→
INFO FACTORY Key
→ → →
POWER ON
→
TV P 1
7. YC Delay
8. Adjust
9. Bus Stop
10. W/B MOVIE
11. Checksum
12. Reset
13. Spread Spectrum
MUTE POWER ON
→
(Interval between key strokes: less than 3 sec)
Troubleshooting
4-17