Cuisinart DGB-2 Series Instruction Booklet page 8

BREWING WITH HOMEBARISTA
1. Remove the water reservoir and fill
to max fill line. Replace back into the
unit. If water is lower than minimum
fill, the Add Water indicator light will
illuminate.
2. Open brew head lever and remove
the capsule holder from the brewing
chamber by pulling toward you.
3. Remove the HomeBarista
Filter Cup from the grinder holder.
Make sure there are no grounds
remaining on the upper rim of the filter
basket. Close the lid and place into the
brewing chamber. There is no need to
snap it into place.
Caution: There are two sharp needles
in the brewing chamber that puncture
the capsule, one above and one below.
To avoid risk of injury, do not put your
fingers in the brewing chamber.
®
Reusable
®
8
4. When the brew head lever is closed,
the Brew Size buttons will illuminate
solid. Press the desired cup size to
begin brewing.
NOTE: Brewing process can be
stopped during brewing. Simply press
selected Brew Size button again to
stop brewing.
5. When the brewing process is complete,
all Brew Size buttons will go off.
The Grind button will remain on for
use until the brew head lever is
opened to begin brewing process
6. After brewing, raise the handle
and remove the HomeBarista
Reusable Filter Cup. Use caution, as
the reusable coffee capsule will be hot.
7. Replace the capsule holder, ensuring
that the arrow on capsule holder rim
aligns with the arrow on the brewing
chamber. Gently push the capsule
holder to snap into place.
NOTE: The HomeBarista
Filter Cup can be filled with pre-
™
ground coffee. Fill the filter basket
within the reusable capsule with ground
coffee, making sure not to fill past the
max indicator. Adjust the amount to
your personal preference. Do not tamp
the grounds. Make sure there are no
grounds remaining on the upper rim of
the filter basket. Close lid. Max fill: 2.5
scoops or 15 grams.
NOTE: This coffeemaker is compatible
with most reusable coffee pods.
®
Reusable
®