How To Measure - Galaxy Innovations ComboF User Manual

8. Navigation Keys:
9. MENU:
10. OK:
11 . :
12. Charging:
13. Reset:
3. H
OW TO MEASURE
Power on the meter, select the system to measure or select system setting to set parameters for the
device in the HOME menu.
In all menus, press [/] button to navigate, press [/] button to change the value of focused
item, press [OK] button to confirm your select, edit value or enter a list to select a wanted item, press
[MENU] button to enter or exit menus.
How to measure satellite signal:
1. Connect the signal cable to F-Type, Female jack.
2. Enter Satellite submenu.
3. Calculate the elevation and azimuth according to your local position in Calculate Angels
menu. Set or adjust your dish to the right position.
4. Set the LNB parameters according to your field environment in LNB Setting menu. Make
sure all the things are correct.
5. Enter to Satellite Measure menu, select the correct satellite and a normal transponder to
check the signal is locked or not.
According to all the output values, such as strength, quality, CNR and power level, you can accurate
your dish to get the best quality signal. And also you can analyzer the signal in Spectrum Chart menu
and Constellation menu to help you to learn the locked signal well. User can edit the satellite position
and transponder in Satellite Edit menu.
How to measure terrestrial signal:
1. Connect the signal cable to IEC-Type, Female jack first.
2. Make sure set Antenna Power to ON in System Setting menu if your antenna needs power
supply.
User`s Manual
F2: Enable/disable deep when pressing keys
F3: Enter to TP control menu in Satellite Measure menu
F4: Enter to Auto DiSEqC function in Satellite Measure menu
/: Move focus or change value.
/: Move focus or change value
Go into main menu or exit from the current menu
Confirm
Turn the meter on/off, press and hold for 2 seconds to power on
the meter.
Connect with the charger cord for charging the equipment.
Reset the meter
3/18