Advertisement
Advertisement
Table of Contents
Related Manuals for JOHNY VAC parke
Summary of Contents for JOHNY VAC parke
- Page 1 USER GUIDE Please read all instructions before using this vacuum cleaner.
- Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precaution should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. WARNING – To reduce the risk of fire, electric shock or injury: 1. Do not leave vacuum cleaner when plugged 10. Keep hair, loose clothing, fingers and all parts in.
- Page 3 PRODUCT VIEW Hose connector Dust collector Big Wheel Cord Rewind Button Power Switch Carry Handle Power Cord Exhaust Filter Multi Surface Tool (optionnal) Hard Floor Tool Telescopic Wand Tool Hanger Crevice Tool Dusting Brush Handle Hose Batteries...
- Page 4 ASSEMBLY 1. Connect the hose to the canister body. Once it snaps, it is in place. To disconnect the hose, squeeze the snaps located on the side of the hose connection and pull out. 2. Connect the handle to the telescopic wand by aligning the insert and securing it in place. Once it snaps, it is in place.
- Page 5 SPECIAL FEATURES 1. VARIABLE SUCTION This machine is equipped with variable suction control to easily go from cleaning carpets and hard floors to delicate surfaces like drapes and upholstery. a. Power Button: Once the vacuum is plugged in, press the main power button to activate the remote control.
- Page 6 OPERATIONS 1. Locate the power cord on the back of the unit and plug in. The power cord can be pulled out until the yellow mark is visible. DO NOT PULL OUT past the red mark on the cord. 2. Turn on the vacuum by pressing the power button on the base of the canister. The vacuum starts 3.
- Page 7 CARE AND STORAGE To maintain maximum performance, perform these simple maintenance steps. 1. Filter assembly, cleaning and replacement a. Remove the dirt bin from the base of the canister. b. Locate the filter on the back of the dirt bin and pull the latches to separate the filter from the bin. c. Separate the pleated filter from the foam filter. d. Clean pleated filter by tapping it lightly against the trash can. e. The foam filter can be rinsed under water. Make sure the filter is dry before replacing. Reassemble the components. 2. Post-motor filter cleaning and replacement a. Locate the exhaust filter on the back of the canister.
- Page 8 TROUBLE SHOOTING Problems Possible causes Remedies Motor is not operating Check that the plug is Re-plug connected to the socket securely Weakened suction power Full dust cup Empty dust cup Clog in the hard floor tool or Follow instructions for cleaning hose the hard floor tool Variable suction set to the...
Need help?
Do you have a question about the parke and is the answer not in the manual?
Questions and answers