Winding The Bobbin - Singer 6199 Instruction Manual

Be sure to use metal Class 15 bobbins.
1. Place a spool of thread on the spool
pin, and secure it with the spool pin
cap. Pull the thread out from the spool
and place it through thread guides as
shown in illustration.Be sure to pull
thread securely into the bobbin winding
tension disk.
2. Put end of thread through the hole in
bobbin as shown.Push bobbin winder
shaft to far left position, if it is not
already there.
3. Place bobbin onto shaft with end of
thread coming from top of bobbin.
Push bobbin winder shaft to the right
until it clicks. Hold the end of thread.
4. Start machine and the bobbin starts
to wind. Bobbin will automatically stop
turning when completely filled. Push
shaft to the left to remove bobbin and
cut thread.
8

WINDING THE BOBBIN

1
2
3
4