Carburetor - Idle Setting - Husqvarna TC 125 2021 Owner's Manual

15 TUNING THE ENGINE
Needle overview
The jet needles available are shown in the following table.
Column 2 corresponds to a needle in the standard position.
Column 1 corresponds to a needle which is half a clip leaner.
Column 3 corresponds to a needle which is half a clip richer.
Column 4 specifies the diameter of the first cylindrical part of the needle. The smaller the diameter of the first
cylindrical part of the needle, the richer the mixture preparation. The larger the diameter of the first cylindrical
part of the needle, the leaner the mixture preparation. The first cylindrical part of the needle has the greatest
influence in the lowest load range.
15.4
104
Info
The top right jet needle A3 corresponds to the richest setting of the carburetor, and the bottom left jet
needle F1 corresponds to the leanest. The optimal carburetor tuning is shown under the respective
model.
B00075-10
Carburetor – idle setting
402799-10
Clip position
1 ... 5 Clip position from above
The five possible clip positions are shown here.
The carburetor tuning depends on the defined ambient and oper-
ating conditions.
The idle setting of the carburetor significantly influences the vehi-
cle's starting behavior, the stability of the idle speed, and the
vehicle's response when accelerating. This means that an engine
with a correctly set idle speed will be easier to start than one with
an incorrectly set idle speed.
Info
The carburetor and its components are subject to
increased wear caused by engine vibration. Wear can
result in malfunctioning.
The factory setting for the carburetor is set for the following val-
ues.
Height above sea 301 ... 750 m (988 ... 2,461 ft)
level
Ambient tempera- 16 ... 24 °C (61 ... 75 °F)
ture
402674-01