Table of Contents
Advertisement
10. Removing the Power SW and LED/RMT boards
1) Remove the back cover. (Refer to Item 1.)
2) Remove 3 screws (STP 3x8), then remove the LED/RMT board.
3) Disconnect the 2 wire harnesses from the connector on the LED/RMT board.
4) Remove 2 screws (PP 3x6), then remove the cord holder.
5) Remove 2 screws (STP 3x8), then remove the switch cover and cap.
6) Disconnect the wire harness from the connector on the Power SW board.
7) Remove 3 screws (STP 3x8), then remove the Power SW board.
Wire harness
STP 3x8
Switch cover
PP 3x6
Cord holder
STP 3x8
POWER SW
board
Cap
– 26 –
STP 3x8
LED/RMT board
Wire harnesses
Advertisement
Table of Contents
