Table of Contents
Advertisement
CHAPTER 2 STANDARDS AND ADJUSTMENT
6.
Adjusting the Tension of the Scanner Drive Cable
Move the mirror 1 mount to the home position (start position). As shown in Figure 2-10, pull at
point [A] (approximate center) of the free cable with a spring gauge so that the cable lengths touch
each other. If the reading on the spring balance is not about 1.0 ±0.5 kg, loosen the screws [B] of
Figure 2-9, turn screw [A] to achieve this reading, and then tighten the screws [B].
2-6
1.0 ±0.5 kg
Pulley 2
A
Scanner drive capstan
Figure 2-10 Top View
Mirror
Scanner
2/3
mount
Pulley 1
Pulley 2
Advertisement
Table of Contents
Troubleshooting
