Wolf 39239 Series Mounting Instructions page 31

KGXD - 340 - 430 upright
KGXD is delivered in several parts: casing, plate
elements
(possibly several).
The assembly sequence described below must be adhered to.
Position the lower part of the casing at the place of installation.
If existing bolt to joining unit sections.
Completely remove the panels on the access side (including
door and possible triangle plates).
Note the divisions of the panels and mark them if necessary In
order to keep the same position when reinstalling. Pay attention
to different panel widths.
Remove intermediate stop rails. Remove bolts of support only
from intermediate stop rail.
Remove air flaps.
The casing is now freely accessible.
Insert bypass panel if not yet mounted (pay attention to the
bypass side, opening of the upstands). As well for return air.
Insert the single plate elements into the casing towards the rear
panel or bypass. Insert the elements close to each other. Apply
sealing bond to one side of each element. The upper profile
with support may sag without the intermediate stop rail.
If this occurs the profile has to be held up for inserting the
elements.
3062937_201508 31