Advertisement
OPERATING INSTRUCTIONS
4. The motion sensor feature can be adjusted using the
knob on the left side of the light. There are four (4)
settings:
ON- Allows the lights to stay on indefinitely. This setting
should also be used to check the status of the batteries. If
the lights do not come on when set to the ON position, the
batteries need to be replaced. Operating in this mode will
deplete batteries quickly.
FLASH- Allows the lights to flash (ON and OFF) when
motion is sensed, and continue to flash until the security
light no longer senses motion. Note: A flashing light is
more likely to be noticed by neighbors and attract
attention. The lights will turn off approximately 10 seconds
after motion is no longer detected.
10sec- Allows the lights to come on for 10 seconds when
motion is sensed.
OFF- Disables the lights.
BATTERY REPLACEMENT INSTRUCTIONS
1. Unscrew the rear housing cover screw at the bottom
of the fixture (A) until the fixture (A) comes loose. Tilt
the bottom edge of the fixture (A) upward until it
disengages along the top edge. Remove the fixture (A)
from the rear housing cover. Note: the screw does not
fully come out of the opening.
2. Remove the battery compartment door on the fixture
(A) by grasping the catches located on the right and left
sides of the door, and squeeze together until the catches
release the door from the fixture (A). Insert 4 new alkaline
C cell batteries into the battery compartment according to
the "+" and "-" markings at the bottom of the battery
compartment. Do not mix old and new batteries.
Re-attach the battery compartment door by snapping it
back into place using both thumbs to press it down onto
it's catches. The door will "click" into place. Make sure it
is secure, as the batteries will not make proper contact if
this battery door is not on properly.
3. Re-attach the fixture (A) to the mounted rear
housing cover by angling the bottom away from the
mounted rear housing cover (D), and engaging the
two (2) tabs at the top rear edge of the fixture (A) into
the corresponding openings in the rear housing cover
(D). Once engaged, angle the bottom of the fixture (A)
back toward the rear housing cover (D), and press it
against the rear housing cover (D). While holding it in
place, re-tighten the bottom screw on the fixture (A)
until it engages with the rear housing cover (D), and
holds the fixture (A) in place.
4
C
1
D
2
3
D
5
E
A
D
A
A
D
Lowes.com
A
A
A
A
Advertisement
