Advertisement
ASSEMBLY INSTRUCTIONS
5. Re-attach the LED security light body to the mounted
rear housing cover (D) by angling the bottom away from
the mounted rear housing cover (D) and engaging the
two (2) tabs at the top rear edge of the fixture (A) into the
corresponding openings in the rear housing cover (D).
Once engaged, angle the bottom of the fixture (A) back
toward the rear housing cover (D) and press it against
the rear housing cover (D). While holding it in place,
re-tighten the bottom screw on the fixture (A) until it
engages with the rear housing cover (D), and holds the
fixture (A) in place.
OPERATING INSTRUCTIONS
1. The individual reflector heads (B) can be adjusted side
to side and up/down independently to aim the light(s) in
the direction desired. If over time, the up/down
adjustment tension weakens, the hinging action can be
tightened by tightening the screw located below each
head.
2. The motion sensor (C) can be rotated to position
detection field in the direction of an area to be covered. If
the 2 arrow indicators are aligned, the motion sensor (C)
is focused straight ahead. The motion sensor (C) can be
rotated approximately 45 degrees right or left of center to
more precisely focus on a coverage area. The sensor
uses passive infrared technology to detect heat radiation
of moving bodies.The motion sensor has a maximum
detection field of 140° at a distance of 10 feet, 120° at a
distance of 26 feet and 90° at a distance of 39 feet.
3. A built in dusk-to-dawn sensor prevents the fixture (A)
from turning on during the day. The sensitivity of this
sensor can be adjusted by rotating the control knob on
the right side of the sensor lens. Rotating the knob
clockwise toward the sun symbol will decrease the
sensitivity to light, and allow the security light to come on
during while it is still light out. Rotating the knob
counter-clockwise toward the crescent moon symbol
increases the sensitivity to light, and allows the security
light to come on only at night. Setting the knob
somewhere in between adjusts the photo sensor's
sensitivity to outside light, and is used to trigger the
sensor at different light levels.
5
D
1
2
3
4
A
D
A
C
140°
10 ft./3 m
120°
26.2 ft./8 m
90°
39.4 ft./12 m
F
C
Lowes.com
A
A
Advertisement
