Drive Chain Slack - Yamaha Y16ZR 2021 Owner's Manual

Periodic maintenance and adjustment

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the cen-
terstand.
2. Shift the transmission into the
neutral position.
3. Measure the drive chain slack as
shown.
8
1
1. Drive chain slack
Drive chain slack:
35.0–45.0 mm (1.38–1.77 in)
4. If the drive chain slack is incorrect,
EAU22762
adjust it as follows. NOTICE: Im-
proper drive chain slack will
overload the engine as well as
other vital parts of the motorcy-
cle and can lead to chain slip-
EAU22799
page or breakage. To prevent
this from occurring, keep the
drive chain slack within the
speci ed limits.
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Loosen the locknut at each end of
the swingarm, and then loosen the
axle nut and the brake caliper
bracket bolt.
2. To tighten the drive chain, turn the
drive chain slack adjusting nut at
each end of the swingarm in direc-
tion (a). To loosen the drive chain,
turn the adjusting nut at each end
of the swingarm in direction (b),
and then push the rear wheel for-
ward.
8-24
TIP
Using the alignment marks on each
drive chain puller, make sure that both
chain pullers are in the same position
for proper wheel alignment.
[ECA10572]
EAU66612
1. Locknut
2. Drive chain slack adjusting nut
3. Axle nut
1 2
1 2
3