Controlling The Device - Behringer DIAMOND DOME DD610 Quick Start Manual

42
DIAMOND DOME DD610

Controlling the Device

The device can be controlled in the following ways:
1. Master/slave
2. IR remote
3. DMX control
Master/Slave Control
Master/Slave, automatic setting
1. Connect the device(s) with DMX cable.
2. Master/slave mode will be activated automatically, master unit will be set randomly.
Master/Slave, manual setting (Slave 1 mode operation)
1. Connect the device(s) with DMX cable.
2. Set the master unit:
2.1. Press MENU of the first device and select
2.2. Press ENTER
2.3. Then use up and down to select
2.4. Press ENTER (now the first unit is the master)
2.5. Press MENU on the master device and select
2.6. Press ENTER
2.7. Then use up and down to select show mode 0-16
2.8. Press ENTER
2.9. After 5-10 seconds of inactivity, the show mode will be activated
3. Set the slave unit(s):
3.1. Press MENU and select . (Use the same operation on all the slave units)
3.2. Press ENTER
3.3. Then use up and down to select
3.4. Press ENTER to confirm
IR Remote Control (Option)
When using the remote control, the space between the device and the remote control should be kept free of obstacles.
The remote control has a range of 10 meters.
Button
ON/OFF
AUTO
PRG
SOUND
SPEED
STROBE
+
DIMMING
-
W, A, UV, R,
G, B
1 to 9
Notes
Remote Control Battery
1. The battery positive (+) should face as shown below.
2. The arrow indicates the plastic lock.
43
Quick Start Guide
Function
Press to turn unit on, press again to turn off
Active Show, same as AU0 random
Active Show mode. Use + / - to select the preset program
from AU1 to 16
Turn Sound Control On/OFF. When ON, press + / - to adjust
the sensitivity from 0 to 100 *
Activates speed setting when AUTO and PRG mode is ON. Use
+ / - to adjust the speed from S001 to S099 *
Activates strobe. Use + / - to adjust the speed from 0 to 100 *
Press to increase the current value to a maximum value of
100. Press - to decrease.
Dimmer can be used in AUTO mode, PRG mode, SOUND mode,
and static color.
Press to decrease the current value to a minimum value of 0.
Press + to increase.
Select color for dimmer mode (White, Amber, UV, Red, Green,
Blue)
Select preset color
* Each press of +/- increases/decreases by 1, but if held
down, the values change faster.