Preparing The Brewer For Use - Bunn B10Series Use And Care Manual

PREPARING THE BREWER FOR USE

NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
Step 1
Raise the hinged flip-lid.
NOTE: The post protruding from the screen is
connected to a stopper which controls the flow of
water into the tank. When lid is closed (post depressed),
the stopper is raised and water will flow into the tank.
Step 2
Slide an empty brew funnel into the brewer under
the warmer switch. Pour one decanter full of water
into the screened area on top of the brewer. Place
decanter on the warmer. Close lid. Wait three minutes
to allow the water to flow into the tank. Repeat this
process. When the tank is full, some water will flow
through the funnel and into the decanter.
Step 3
Plug in the brewer.
Step 4
Press the bottom of the vacation switch, located on the
lower left side of the brewer, to the "ON" (lower) position.
The vacation switch controls power to the tank heater.
Initially you will have to wait approximately fifteen
minutes in order for the water to reach brew
temperature.
Empty any water that has collected in the decanter.
You're not done yet! The next page leads you through the five
easy steps to 'BREWING DELICIOUS COFFEE'
6
P2240
P2247
P-214
OF
F
P-219