Clearance Requirements - Avallon AFR242SSRH Owner's Manual

Clearance Requirements

Notes:
• To ensure proper service access and ventilation, allow between 1 - 2 inches of clearance at
the back as shown in the diagram.
• The installation should allow the unit to be pulled forward for servicing, if necessary.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with
National Electrical Code and local codes and ordinances, is required.
When installing the refrigerator under a counter, follow the recommended spacing dimensions shown.
To ensure proper service access and ventilation, allow at least 1-2" of clearance at the back,
/ " at the sides. If the door side is against a wall, allow at least 2
1
4
the unit to be pulled forward for servicing, if necessary.
Top View:
1-2"
1/4"
Note: The refrigerator should be installed on a firm and level surface that will be able to support
the entire weight of a fully loaded unit. It is important for the refrigerator to be level in order to
work properly. If needed, you can adjust the height of the refrigerator by rotating the feet. See the
"Leveling the Refrigerator" section.
Note: A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with
National Electrical Code and local codes and ordinances, is required.
1/4"
90
"
24 3 /
Door Swing
4
1 / "
16
/ " of clearance. The installation should allow
1
16
Side View:
2 / "
/ " at the top, and
1
4
9