Table of Contents
Advertisement
Q
N
e
u
exus
diTOr
If both Keyboard Layer and Controller Layer are enabled, the selected key will send out everything
that you have assigned it here in Controller Layer Tab and also in the Keyboard Layer Tab� For Example:
if you turn Channel Pressure on and Pitch Bend set to Tilt in Keyboard Layer and have all 4 sources on
in Controller Layer, then that Key will send out 2 notes, Channel Pressure, Pitch Bend, and CC values
for an additional Pressure, Tilt, and Toggle source� Controller Layer assignments will not increment
or decrement when using the -Oct+ buttons� Neither will they Rotate Channels if Channel Rotation is
enabled in Keyboard Layer�
4.1 1.1.2 C
ONTrOller
Now it is established that it is necessary to enable "Participate in Controller Layer" for any keys you
wish to assign Controller Layer Notes or CC#s to� Controller Layer has 4 sources of its own that can be
assigned per key: Notes, Toggles, Pressure and Tilt� Use the Note Number, Toggle CC, Pressure CC, and
Tilt CC number boxes to set which Note number or CC number the selected key will use for each source�
Setting these number boxes to "-1" will turn the sources off�
Under the Pressure and Tilt CC number boxes are the Pressure CC Return and the Tilt CC Return number
boxes� These set what values the Pressure and Tilt CC#s will return to when released� For example, if the
Tilt CC Return box is set to 63, when you release the key the tilt source will go to 63� Tilt and Pressure
can also latch; if the Return boxes are set to "-1" ("latch"), then they will stay at the value when they are
released�
Specify Controller Layer's Note Velocity with the Note Velocity Number box� Set this number box to "-1"
("var") to turn velocity response on and allow it to vary depending on pressure�
4.1 1.1.3 C
ONTrOller
There is a dedicated CC# for Toggling in Controller Layer� This has nothing to do with the Toggle options
in Keyboard Layer� In fact, you must disable "Participate in Keyboard Layer" in order to use the Toggle
CC#� This is because Keyboard Layer has its own built in Toggle behavior which cannot interact with
Controller Layer's Toggle�
With Keyboard Layer disabled, to use toggle in Controller Layer, turn the Toggle On/Off check box on
and set the Toggle CC, Toggle CC Value, and Toggle CC Return parameters�
Toggle CC - This is where you choose which CC number will toggle�
Toggle CC Value - This represents the CC value that will output when the Toggle state is ON�
Toggle CC Return - This represents the CC value that will output when the Toggle state is OFF�
Any Notes assigned on the same Controller Layer key with Toggle enabled will toggle with the CC
number� The Note Velocity number box will be the velocity that outputs when the Toggle state is ON�
The LEDs will indicate the toggle state�
l
s
ayer
OurCes
l
T
ayer
OGGle
Q
N
2.0
u
exus
39
Advertisement
Table of Contents
