Technical Specifications; Operation - Ugo SQUBBY 8 Original User Manual

THANK YOU FOR PURCHASING THE UGO ELECTRIC SCOOTER.

TECHNICAL SPECIFICATIONS:

• Max driving speed: 24 km/h
• Operating temperature: +5°C to +40°C
• Battery type: Li-ion 36 V, 5 Ah
• Max load capacity: 120 kg
• Net weight: 8.5 kg
• Power rating: 250 W
A. UNFOLDING
2
1
D. EXPLANATION OF THE CONTROL KEYS AND CHARGING POR
SAFETY PRECAUTIONS FOR USE
• Follow this user manual strictly to use the product safely.
• CAUTION! Wear approved riding helmet, knee pads, wrist pads and elbow pads when riding this vehicle.
• CAUTION! The product is not compliant with general public road traffic regulations. Do not operate it on public roads for motor
vehicles or pedestrian ways. Always mind the people around you when riding this vehicle.
• Fully charge the battery before operating the electric scooter for the first time. Never drain the battery completely. Recharge
the battery only with the original power adapter included with the product. The battery contains hazardous chemicals. Do
not attempt to open the battery casing or refill it on your own.
• Always ride the electric scooter at a safe distance from bystanders.
• The recommended minimum age for using this product is 14. This product is intended for operation and riding by one person
at a time. Children, seniors and pregnant women should not ride the electric scooter.
• Operate the electric scooter on a level and smooth surface only. Avoid riding on steep or icy ground, rough terrain or stairways.
Smooth surfaces are a risk of skidding and falling. Never operate this vehicle when visibility is poor. Never leave this vehicle
unattended, also while recharging the battery. Inspect the vehicle before each use for damage, wear and loose fasteners.
• CAUTION! Do not attempt to jump with this vehicle!
• Do not attempt to modify the product, otherwise you might render it unsafe for use. This product features no user-serviceable
parts. Do not attempt to repair it on your own. Always have a professional repair the product for you.
• Keep the product away from risk of ingress of water or other liquids into its enclosure. The product and its power adapter are
not water-proof. Do not operate either close to water or in very wet areas.
• CAUTION! The motor can become hot after prolonged operation. Do not touch until it cools down as it is a burn hazard!
• Noise emission: The equivalent sound pressure level does not exceed 70 dB.

OPERATION

Refer to Fig. A and B, which show how to fold and unfold the electric scooter. Make sure that the folding lock is fully engaged
after unfolding and before using the electric scooter.
Step 1. Start the electric scooter by pressing the power switch (C). The electric scooter will be ready to use after a short while.
Step 2. Place your foot firmly at the correct location on the deck. Push yourself forward with the other foot. Control the riding
direction and maintain balance with your body. Do not move your body abruptly when on the deck.
Step 3. Press the accelerator lever (D) down to go faster.
Step 4. Release the accelerator lever (D) to slow down. You can switch between speed modes with the speed mode selector (K).
Step 5. Press the brake lever (E) to come to a stop. Avoid braking hard.
Step 6. Stepping off the electric scooter: stop the electric scooter completely before getting off.
MISCELLANEOUS SAFE RIDING TIPS
• Practice riding the electric scooter in a wide open area until you master stepping on the scooter, riding forward, turning while riding,
braking, stopping and stepping off the electric scooter. Wear comfortable sports clothing, which provide unrestricted movement in
an emergency.
• If you are riding too fast or repositioning the weight of your body, maintain balance so as not to fall off the electric scooter. Adapt
your riding speed to stay safe and be safe to others near you. The faster you ride, the longer the braking distance is. If you are riding
along with other electric scooter riders, keep a safe distance between one another to avoid a collision. You are 12 cm taller when
standing on the electric scooter deck. Keep your head low when riding through a door or under relatively low obstacles to avoid injury.
IN THE BOX:
• 1 x uGo SQUBBY electric scooter
• 1 x power adapter and charging cable
• 1 x user manual
• 1 x set of tools
B. FOLDING
2
B
H
E
G
1
K, I
A
C
K
D
RECHARGING THE BATTERY
• As the battery power level becomes lower, so does the maximum riding speed of the electric scooter. When the battery power
level is at the minimum, riding further may reduce the battery life at the next full charge. It is highly recommended to turn off the
electric scooter and connect it to its power adapter:
• Make sure that the electric scooter is turned off.
• Connect the power adapter to the charging port (G) of the electric scooter.
• Connect the power adapter to a mains outlet.
• When the battery is fully recharged, the power adapter LED will turn from red to green.
• CAUTION! Do not leave the electric scooter connected to the mains through the power adapter for longer than necessary to
completely recharge the battery. Use only the power adapter included. The temperature of the electric scooter must be between
+10°C and +30°C before and during recharging the battery. This will optimise the recharging and the battery life.
CLEANING, STORAGE AND TRANSPORT
• Proper and frequent cleaning makes the use of the electric scooter safe and extends its life. Remove dirt and grime from
all parts of the electric scooter with a dry cloth. Caution! Do not clean with any strong chemicals, alkalis, abrasives or
disinfectants. Otherwise, the surface finish of the electric scooter parts can be damaged.
• Caution! Never immerse the electric scooter and/or the power adapter in water or other liquids.
• Keep the electric scooter in a dry and ventilated place away from children. Do not expose the electric scooter to vibration
or shocks when in transport.
• Frequently check the battery power level and recharge it as needed. Before prolonged storage, recharge the battery to
between 30% and 50%.
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) DISPOSAL
The safe product, conforming to the EU requirements.
The product is made in accordance with RoHS European standard.
The WEEE symbol (the crossed-out wheeled bin) usage indicates that this product is not a household waste. Appropriate
waste management aids in avoiding consequences, which are harmful for people and environment and result from dangerous
materials used in the device, as well as, improper storage and processing of such equipment. Segregated household waste
collection allows recycling of materials and components of which the device was made of. In order to get detailed information
about recycling of this particular product, please contact your retailer or a local authority.
This Impakt S.A. declares that the device complies with the essential requirements and other applicable provisions of the
applicable EC directives. Full text of the CE declaration can be downloaded from the website of the distributor www.ugo-
europe.com.
Importer: Impakt S.A. ul. Stanisława Lema 16, 62-050 Mosina, Poland.
Caution! The design and technical specifications of this product can change without prior notice. The manufacturer shall not
assume any liability for any discrepancies caused by errors (if any) in this user manual.
C. INSTALLING THE HANDLEBAR GRIPS
ELECTRIC SCOOTER COMPONENTS (FIG. D)
• A. Current driving speed
• B. Battery power level
• C. Power switch
• D. Accelerator lever
• E. Brake lever
• G. Charging port
• H. Active speed mode
• I. Headlight switch
• K. Speed mode selector (3rd speed: maximum speed limit; 2nd speed:
moderate speed limit; 1st speed: minimum speed limit)
EN