Download Print this page

TOTALINE PCTT0000A Operating Instructions Manual page 3

Hydraulic flaring and swaging

Available languages

��

* OIL CHECK *

Please note that oil check should only be done if there are traces of oil found suggesting

some type of leak.

Check hydraulic oil level. Hydraulic oil can be checked by unscrewing back part of hydraulic

cylinder. Rotate endcap (round textured section under pump handle) counterclockwise until sepa-

rated from main body. Hold tool vertical with rubber reservoir at top. Remove small plug from end

of reservoir. With piston in full retract position, hydraulic oil should ﬁll reservoir. Add hydraulic oil

as needed. Use hydraulic oil with a viscosity of about 46. Replace plug and endcap.

Part#

Description

71700-A

Flaring & Swaging Pump 71700-04 1/4" Swaging Adapter

71700-B

Yoke Assembly

71700-01 45˚ Flaring Cone

71700-PB Plastic Molded Box

��

SWAGING ADAPTERS

Part#

Description

71700-05 5/16" Swaging Adapter 71700-105 5/16" Die Set

71700-06 3/8" Swaging Adapter

71700-08 1/2" Swaging Adapter

71700-10 5/8" Swaging Adapter

71700-12 3/4" Swaging Adapter

71700-14 7/8" Swaging Adapter

��

SWAGING DIE SETS

71700-104 1/4" Die Set

71700-106 3/8" Die Set

71700-108 1/2" Die Set

71700-110 5/8" Die Set

71700-112 3/4" Die Set

71700-114 7/8" Die Set