Flex FX1551A Operator's Manual page 12

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR (FIG. 9)
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located above the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool to drill holes (Fig. 9).
b. Position the direction-of-rotation selector to
the far right of the tool to remove drill bit from
holes (Fig. 9).
c. Position the switch in the "OFF"
(center-lock) position to help reduce the
possibility of accidental starting when not in
use.
LED LIGHT (FIG. 10)
Your tool is equipped with an LED light, located
on the base of the tool. This provides additional
light on the surface of the workpiece for
operation in lower-light areas.
The LED light will automatically turn on with
a slight squeeze of the variable-speed trigger
switch before the tool starts running and will turn
off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
ADJUSTMENTS
After tool use, lock the
direction-of-rotation
Fig. 9
NOTICE: To prevent gear damage, always
allow the tool to come to a complete stop before
changing the direction of rotation.
NOTICE: The tool will not run unless the
direction-of-rotation selector is engaged fully to
the left or to the right.
Fig. 10
LED Light
-12-