Table of Contents
Advertisement
Available languages
Available languages
WARNING
careful when the tool is not in use or when
carrying it at your side.
ON/OFF SWITCH
To turn the tool ON, press the switch from the
"I" position (Fig. 11). The LED will light when the
tool is turned on.
To turn the tool OFF, press the switch from the
"O" position (Fig. 12).
LED WORKLIGHT (FIG. 13)
Your tool is equipped with an LED worklight
located on the top of the tool. This provides light
on the surface of the workpiece for operation in
lower light areas.
The LED worklight will illuminate when the tool
is turned on and will turn off 10 seconds after
the tool is turned off.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED worklight will rapidly
flash. Rest the tool for a while or place the tool
and battery pack separately under flowing air to
cool them.
The LED worklight will flash more slowly to
indicate that the battery pack is at low battery
capacity. Recharge the battery pack.
OPERATION INSTRUCTIONS
Battery tools are always in
operating condition. Be
Fig. 11
Fig. 12
Fig. 13
-12-
LED
Worklight
Advertisement
Table of Contents
