Flex FX2471 Operator's Manual page 11

ADJUSTING DEPTH GUIDE (FIG. 8)
Use the tool-free depth adjustment to set the
depth guide before each cut.
a. Loosen the thumb screw counterclockwise.
b. Slide the depth guide to the desired position.
c. Tighten the thumb screw clockwise to secure
the depth guide.
For best results, set the depth guide so that the
cutting bit will extend
workpiece.
NOTICE: Check for adequate clearance
beneath the workpiece before cutting so as
not to strike a hard surface such as the floor,
workbench, etc.
VENT-DIRECTION SELECTOR
Your tool is equipped with a vent-direction
selector, located on the front of the tool. This
vent-direction selector is designed to blow dust
in different directions as needed for various
applications.
a. Slide the vent-direction selector to the far left
of the tool to blow dust from the side
(Fig. 9).
b. Slide the vent-direction selector to the far right
of the tool to blow dust from the top of the tool
(Fig. 10).
ADJUSTMENTS
1/8" (3mm) beyond the
Fig. 8
Fig. 9
Fig. 10
-11-
c
b
a