Advertisement
Quick Links
Advertisement
Related Manuals for Genexis FiberTwist Bracket
Summary of Contents for Genexis FiberTwist Bracket
- Page 1 FiberTwist Product Series Bracket Quick Installation Guide...
-
Page 2: Installation
If necessary, pre-drill the holes and insert the plugs. Determine fiber ingress location Screws The rear of the FiberTwist Bracket offers a choice of three fiber ingress locations as shown circled in red on the photo below. front view... - Page 3 Attach patch cord 3.2. Remove the dust cap from one end of the patch cord. If your patch cord has a connector with a short boot, make sure you remove the cap from Remove the green connector from the bracket. the end with the short boot.
- Page 4 Place connector and patch cord back in bracket 4.2. Depending on which fiber ingress port was chosen, run the patch cord through the fiber management system in the appropriate fashion. Insert the connector back in the Bracket and run the patch cord through the fibre management system.
- Page 5 Attach to wall Using the supplied screws, affix the Bracket to a flat wall. Make sure the front side of the Bracket is facing you as shown below. Warning: Make sure the fibre passes through the egress port cleanly and doesn’t get pinched between the edge of the Bracket and the wall.
Need help?
Do you have a question about the FiberTwist Bracket and is the answer not in the manual?
Questions and answers