Sony HT-SS380 Operating Instructions Manual page 26

The table below provides measurement
status shown on the display panel.
Measurement for
Speaker existance
Speaker gain, distance,
frequency response
Subwoofer gain and
distance
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you perform the following
during the measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote control or
INPUT +/– on the receiver.
– Change the volume level.
26
US
Display
TONE
T S P
WOOFER
3: Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement process is
completed, the result appears on the
display panel with a beep sound.
Measurement process
[Display]
Completes properly
[SAVE EXIT]
Fails
[E - xxx xx]
2
View the measurement result.
Press V/v repeatedly to select the item,
then press .
• EXIT
Exits the setting process without saving
the measurement results.
• WARN CHECK
Displays warning related to the
measurement results. See "Checking the
warning message" (page 27).
• SAVE EXIT
Saves the measurement results and exits
the setting process.
• RETRY
Performs the Auto Calibration again.
3
Save the measurement result.
Select "SAVE EXIT" in step 2.
"COMPLETE" appears on the display
panel and the measurement results are
saved.
4
Disconnect the optimizer
microphone from the receiver.
Note
If you reposition your speaker, we recommend that
you perform Auto Calibration again to enjoy the
surround sound.
Do this
Proceed to step
2.
See "When error
codes appear"
(page 27).