Specifications - Sony HT-SS380 Operating Instructions Manual

Error messages
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "When error codes
appear" (page 27) to solve the problem.
PROTECTOR
Irregular current is output to the speakers,
the volume level is too high, or the upper
panel of the receiver is covered and
ventilation holes are blocked. The receiver
will automatically turn off after a few
seconds. Check the speaker connection and
remove the object covering the ventilation
holes.
Turn on the power and increase the volume
level.
Clearing the memory
If you are unable to remedy the problem using
the troubleshooting guide, clearing the
receiver's memory may remedy the problem.
However, note that all memorized settings will
be reset to the default settings and you will
have to readjust all settings on the receiver.
Reference sections
To clear
All memorized settings

Specifications

AUDIO POWER
SPECIFICATIONS
Amplifier section
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(FTC)
(USA model only)
FRONT L + FRONT R
POWER OUTPUT (reference)
FRONT L/FRONT R/CENTER/SUR L/SUR R
SUBWOOFER
Inputs
Analog
Digital (Coaxial) Impedance: 75 ohms
FM tuner section
Tuning range
Antenna
Antenna terminals
General
See
Power requirements 120 V AC, 60 Hz
page 24
Power output (DMPORT)
DC OUT:
Power consumption 110 W
Power consumption (during standby mode)
With 3 ohm loads, both
channels driven, from 180
– 20,000 Hz; rated 84 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250
milliwatts to rated output.
167 W (per channel at
3 ohms, 1 kHz)
165 W (at 3 ohms, 60 Hz)
Sensitivity: 1 V/50 kohms
87.5 MHz – 108.0 MHz
(100 kHz step)
FM wire antenna (aerial)
75 ohms, unbalanced
5 V, 1 A MAX
0.3 W (When Control for
HDMI is set to off)
continued
49 US