Installation; Operation - Power Fist 0450071 Owner's Manual

V 1.45

INSTALLATION

1. Set the air pressure regulator on the air compressor to 90 PSI.
2. Prepare a standard 1/4" air connector for use with your tool. Wrap the threaded portion of the air
connector with thread tape. Attach it to the tool's air inlet. Tighten securely.
Note :
If you are not using an in-line oiler, add a few drops of air tool oil in the tool's air inlet before use. In the same
manner, add a few drops after every hour of use.
3. Attach a standard quick connector to the air source's hose. Attach the air hose to the tool.
Warning:
Do not exceed the tool's recommended air pressure. Excess pressure could result in damage to the tool, to
your work piece or serious injury.
4. Check the air line and its connections for air leaks. Do not use this tool until you have repaired all air
leaks.
Note:
Turn off the air compressor, disconnect the air pressure hose and discharge any residual pressure inside
the tool before changing accessories or making any adjustments to the tool. Failure to do so could result in
severe injury, tool or property damage.

OPERATION

1. Suggested air pressure is 43 PSI
2. Recommended paint viscosity differs according to paint properties and painting conditions.
3. Use the lowest possible fluid output that produces an adequate paint coverage. Finer atomization leads
to a better finish.
4. The gun should be held so that it is perpendicular to the surface of the workpiece at all times. Move
the gun in a straight and horizontal line. Arcing the gun results in an uneven paint finish.
5. Keep a distance of 6" to 12" between the paint spray gun and the surface to be painted.
6. In order to obtain a uniform finish during painting, keep the paint spray gun perpendicular and at a
constant distance from the surface to be painted.
7. Spray the paint in horizontal swatches. If the finish is not adequate, make sure that the pressure is not
too low and that the paint spray gun is not being held too far from the surface to be painted.
For any technical questions, please call 1-800-665-8685
5
0450071