Specifications - Sony HT-DDW960 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 8 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than 0.7%
total harmonic distortion from 250 milliwatts to
rated output.
Amplifier section
Power Output
(8 ohms 1 kHz, THD 10%)
See
FRONT
page 17
CENTER
page 32
SURR
SURR BACK
1) Measured under the following conditions:
120 V AC, 60 Hz
2) Depending on the sound field settings and the
source, there may be no sound output.
Inputs (Analog)
MULTI CH IN,
SA-CD/CD, MD/TAPE,
DVD, VIDEO 1, 2
Inputs (Digital)
DVD (Coaxial)
VIDEO 2, SA-CD/CD
(Optical)
Outputs (Analog)
MD/TAPE (OUT),
VIDEO 1 (AUDIO OUT)
SUB WOOFER
Reproduction frequency range:
Tone
Gain levels
1)
2)
: 120 W/ch
2)
: 120 W
2)
: 120 W/ch
2)
: 120 W
Sensitivity: 800 mV
Impedance: 50 kiloohms
Sensitivity: –
Impedance: 75 ohms
Sensitivity: –
Impedance: –
Voltage: 800 mV
Impedance: 10 kiloohms
Voltage: 2 V
Impedance: 1 kiloohm
28 – 20,000 Hz
±6 dB, 1 dB step
continued
49 US