Electrolux ERE 39353 X User Manual page 11

Problem
The temperature in the
appliance is too high.
The temperature in the re-
frigeration is too high.
The appliance does not
operate.
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.
Possible cause
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too high. Let the food temperature de-
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The door has been open to long. Close the door.
The lamp is defective.
Set a lower temperature.
Refer to "Closing the door".
crease to room temperature be-
fore storage.
Make sure that there is cold air cir-
culation in the appliance.
Insert smaller quantities of food to
be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the lamp".
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 11
Solution