Specifications - Sony HT-DDW670T Operating Instructions Manual

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 60 watts per channel
minimum RMS power, with no more than 0.7%
total harmonic distortion from 250 milliwatts to
rated output.
Amplifier section
1)
Power Output
(6 ohms 1 kHz, THD 10%)
2)
FRONT :
2)
CENTER :
2)
SURR :
(6 ohms 100 Hz, THD 10%)
2)
SUB WOOFER :
1) Measured under the following conditions:
120 V AC, 60 Hz
2) Depending on the sound field settings and the
source, there may be no sound output.
Inputs (Analog)
SA-CD/CD, DVD,
VIDEO 1, 2
Inputs (Digital)
DVD (Coaxial)
SA-CD/CD (Optical)
Output (Analog)
SUB WOOFER
Reproduction frequency range:
Tone
Gain levels
100 W/ch
100 W
100 W/ch
100 W
Sensitivity: 800 mV
Impedance: 50 k ohms
Sensitivity: –
Impedance: 75 ohms
Sensitivity: –
Impedance: –
Voltage: 2 V
Impedance: 1 k ohm
28 – 20,000 Hz
±6 dB, 1 dB step
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
AM tuner section
Tuning range
With 10-kHz tuning scale: 530 – 1,710 kHz
With 9-kHz tuning scale: 531 – 1,710 kHz
Antenna
Intermediate frequency
3) You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off the
receiver. While holding down PRESET TUNING +
or TUNING +, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the procedure.
General
Power requirements
Power consumption
Power consumption (during standby mode)
Dimensions (w/h/d) (Approx.)
Mass (Approx.)
87.5 - 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz
3)
3)
Loop antenna
450 kHz
120 V AC, 60 Hz
160 W
0.2 W
430 × 145 × 301.5 mm
(17 × 5 6/8 × 11 7/8 inches)
including projecting parts
and controls
6.5 kg (14 lb 6 oz)
continued
39 US