Nokia RH-57 Series Troubleshooting Manual page 8

2112 (RH-57)
Troubleshooting - RF
5. Select the Rho ON check box on the CDMA Control dialog box.
6. Click Execute.
7. At this point you should be able to measure Tx Pout at the RF connector. The cell
band Tx Pout =0 to 2 dBm. If you do not see these values, set the AGC PDM for
25 dBm and probe the Tx path to figure out where in the path the fault occurs.
8. Open the General I/O dialog box to set the PA gain state.
9. Enter 10, 13, 12, and 8 in the PIN # fields.
10. Select the boxes in the Enable column for each pin.
11. Click the Get All button.
Page 8
Figure 5: CDMA Control dialog box for Tx troubleshooting
Figure 6: General I/O dialog box for Tx troubleshooting
©2004 Nokia Corporation
Nokia Customer Care
Company Confidential Issue 1 07/2004