How To Use - Panasonic CS-S9TKV Manual

How to use

To reach temperature quickly
• The unit controls set temperature according to
room temperature to accelerate room cooling.
Set
i AUTO-X
temperature
• After max 4 hours, the set temperature is shifted
according to activity detection.
• Fan speed is fixed at AUTO, fan speed selection
is prohibited.
• During unit is off, press
with i AUTO-X mode.
• i AUTO-X mode can be cancelled by pressing the
respective button again.
To select operation mode
MODE
i AUTO-X - To reach temperature quickly
COOL - To enjoy cool air
DRY - To dehumidify the environment
To maximise comfort while
SLEEP
sleeping
(CANCEL)
• This operation provides you with a comfortable
environment while sleeping. It will automatically
adjust the sleep pattern temperature during the
activation period.
• The indoor unit indicator will dim when this
operation is activated. This is not applicable if the
indicator brightness has been manually dimmed.
• This operation is incorporated with the activation
timer (0.5, 1, 2, 3, 4, 5, 6, 7, 8 or 9 hours).
• This operation can be set together with timer.
Sleep operation has the priority over OFF timer.
• This operation can be cancelled by pressing the
respective button when the sleep timer reaches 0.0h.
To enjoy quiet operation
QUIET
• This operation reduces airflow noise.
Auto OFF/ON button
AUTO
OFF/ON
16
ACXF55-04370_YZ0517-1.indb 16 ACXF55-04370_YZ0517-1.indb 16
-1°C /
-2°F
Max = 4 hours
will turn on the unit
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• Press the button once to use in i AUTO-X mode.
• Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
• Press the button again to turn off.
Human activity Indicator
sensor
Remote control
display
OFF/ON OFF/ON OFF/ON
MODE
TEMP TEMP
SLEEP
AIR SWING
QUIET
FAN SPEED
ON ON SET SET
TIMER TIMER
OFF OFF CANCEL CANCEL
AIR CONDITIONER AIR CONDITIONER
To select fan speed
FAN SPEED
(Remote control display)
AUTO
FAN
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• If i AUTO-X mode is set, fan speed is fixed to
AUTO. To adjust fan speed, cancel i AUTO-X mode.
Sunlight sensor
and remote
control receiver
(Green)
POWER
(Orange)
TIMER
(Green)
ECONAVI
(Blue)
nanoe-G
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press and hold for
approximately
5 seconds to show
12-hour (am/pm) or
24-hour time indication.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
6/2/2017 2:30:34 PM 6/2/2017 2:30:34 PM