Operation Instructions - KNOVA KN CM-11MA Manual

ASSEMBLY
INSTALL THE DUST CHUTE
Slide dust chute onto end of chip exhaust. Tighten the pan
head screw.
Dust
chute

OPERATION INSTRUCTIONS

Jointing is a surfacing operation in which a small amount of
wood is removed from the edges and faces of boards to get
smooth, straight and even surfaces such that the two edges
that run across the planning blocks would fit together
perfectly, forming a seamless joint.
Planing refers to the sizing of lumber to a desired thickness
while creating a level surface parallel to the opposite size of
the board. Depth of cut is the term used to indicate how deep
the blades will cut into the workpiece.
ADJUST THE DEPTH OF CUT
• The depth of cut is adjusted by the relative positioning of
the infeed table with respect to the cutterhead. Infeed
table can be raised or lowered using the handwheel.
• Turning the handwheel counterclockwise will lower
the infeed table causing more wood to be removed
from workpiece.
• Turning the handwheel clockwise will raise the infeed
table causing less wood to be removed from workpiece.
• Do not make jointing or planing cuts deeper than 1/8".
• The depth of cut is showed by cutting depth display.
INSTALLING THE FILTER BAG
Open the zipper on the bottom
of the bag, place the spring inside of
the filter bag arm. Slide the arm with
the spring over the dust exhaust port.
Close the zipper.
Filter bag
Mounting
jointer to
bench table
For effective and safe operation, the jointer should be
mounted to a bench table. Use the four mounting holes on
body to fix the jointer to a bench table.
442 mm
Cutting depth display
5
Spring
ø 9 mm
Infeed
table
Handwheel