Assembly - KNOVA KN CM-11MA Manual

ASSEMBLY

ASSEBLE THE FENCE
• Align the T-slot on the fence to the nut on fence support
assembly, slide the fence onto the nut until the arc groove
align the fence support center. Tighten the four flat head
screws to fix the fence.
Fence
Fiat head screw
Arc groove
• Remove the two socket pan head
screw form the jointer. Attach
the fence sliding base to
the jointer, fix it by using
the two socket pan
head screws.
• Fix the fence and fence support
onto the sliding base by using
lock handle, flat washer
and square nut.
Nut
Fence sliding base
Socket pan
head screw
Lock
handle
Square nut
4
CHECK AND ADJUST THE FENCE ANDGE
Before adjusting the fence, make sure the power
is turn off.
• Using a combination square, check and set the fence
perpendicular to the table. If necessary, adjust the 0º
stop and set angle pointer at 0º.
Combination
square
Angle pointer
• Using the combination square, check the 45º angle
between the fence and table. If necessary, adjust
the 45º stop.
Combination
square
ATTENTION
The lowest line of the fence should always seat on
the outfeed table.
0º stop
45º stop