Recording Using The Receiver - Sony STR-DH830 Operating Instructions Manual

• Some time may be needed to start playback
when:
– the folder structure is complex.
– the memory capacity is excessive.
• This receiver does not necessarily support
all the functions provided in a connected
USB device.
• The playback order for the receiver may
differ from the playback order of the
connected USB device.
• Folders that have no audio files are skipped.
• When playing a very long track, some
operations may cause playback delay.
USB message list
Message and explanation
Reading
The receiver is recognizing and reading information
of the USB device.
Device Error
The memory of the USB device could not be
recognized (page 45).
No Support
An unsupported USB device is connected, an
unknown device is connected, or the
USB device is connected through a USB hub
(page 45).
No Device
No USB device is connected or the connected USB
device is not recognized.
No Track
No track was found.
Recording using the
receiver
You can record from an audio/video
equipment using the receiver. Refer to the
operating instructions supplied with your
recording equipment.
1
Prepare the source for playing.
Use the input button (or INPUT
SELECTOR on the receiver) to select the
source.
For example, select SAT/CATV.
2
Prepare the recording
equipment.
Insert a blank video tape, etc. into the
recording equipment (connected to
VIDEO 1 OUT jacks).
3
Start recording on the
recording equipment, then start
the playback equipment.
Notes
• Some sources contain copyright protection to
prevent recording. In this case, you may not be able
to record from the source.
• Audio and video input signals via HDMI IN,
COMPONENT VIDEO IN and DIGITAL IN jacks
cannot be recorded.
• While only composite video signals are being
recorded, the auto standby function of the receiver
may start up and interrupt the recording. In this
case, set the "Auto Standby" to "OFF" (page 67).
GB
47