Error Messages - Sony STR-DH830 Operating Instructions Manual

"BRAVIA" Sync (Control for
HDMI)
The Control for HDMI function does not
work.
• Check the HDMI connection (page 23).
• Make sure "Ctrl for HDMI" is set to "ON"
in HDMI Settings menu.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• If you unplug the HDMI cable or change
the connection, repeat the procedures of
"Preparing for the "BRAVIA" Sync"
(page 56).
• When "Ctrl for HDMI" is set to "OFF",
the "BRAVIA" Sync does not work
properly, even if the equipment is
connected to the HDMI IN jack.
• The types and the number of equipment
which can be controlled by the
"BRAVIA" Sync are restricted in the
HDMI CEC standard as follows.
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
equipment
– Playback equipment (Blu-ray Disc
player, DVD player, etc.): up to 3
equipment
– Tuner-related equipment: up to 4
equipment
– AV receiver (audio system): up to 1
equipment
Remote control
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver (page 9).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.

Error messages

If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver, check the speaker connection, and
turn on the power again.
USB FAIL
An over current from the
detected.
This receiver will automatically turn off
after a few seconds. Check the iPod/iPhone
or USB device, then unplug it and turn on
the power again.
For other messages, see "Message list after
Auto Calibration measurement" (page 37),
"iPod/iPhone message list" (page 44) and
"USB message list" (page 47).
Clearing the memory
Reference sections
To clear
All memorized settings
Customized sound fields
(USB) port was
See
page 32
page 55
GB
81