Display And Monitoring Panel; First Time Setup; Room Size Selection - Omni OCA 500 Operation And Maintenance Manual

Display and Monitoring Panel

First Time Setup

Plug OCA unit into appropriate power source. The power button will flash green.
Press power button . The unit will perform an internal safety/maintenance check. If
there are any safety or maintenance issues, one or more of the HEPA, UVGI or PREFILTER
indicators will turn red and the housing light for that area will flash blue. If this occurs,
consult the Troubleshooting section of this manual.
You will then access the Enter Guided Setup
screen. Press OK to enter room size and
room ID information, or select Do this later to
bypass setup. (Note: if all steps in the Guided
Setup are not completed, machine cannot
display Air Changes per Hour for the room in
which it is operating)
Enter Units prompts to select either US
Standard (ft., in.) or Metric (M,cm ). You can
also enter "Go Back" to return to the previous
menu.
Enter Room Size gives you the option to
either enter the dimensions of the room the
unit will be in, the volume of the room (if
known), or "I don't know". "I don't know" sets
the unit at its highest output.
If DIMENSIONS or VOLUME is chosen, use the
UP/DOWN arrows to increase or decrease
the highlighted dimension or room size.
Press OK to enter. The display will then
advance to the next selection. Press OK when
complete.
4