Fame Audio MS 2002 D User Manual page 29

ENGLISH
Bridge mode:
In bridge mode, the output powers of both power amplifier channels are combined so that twice
the output power is available and both channels function as a single channel. In this case only the
signal of one channel is output. Both controls for signal amplification are used and must be at the
same level.
The connection of the other input channel can be used to loop the input signal through to another
output stage.
To activate the bridge mode, set the switch to "Bridge".
Warning:
Please note that bridge operation results in a much higher output voltage and current
consumption than in the other two modes. Therefore, pay special attention to the correct position
of the input gain control and to the maximum power handling capacity of the connected speaker
cabinets and make sure that the speaker cabling can handle the high power.