Panasonic EYFGA1N Operating Instructions Manual page 32

Configuring Tool Settings
RPM adjustment setting
1. Turn off the control panel.
• If the control panel is on, remove and
then reinsert the battery pack.
. Depress the switch while pushing the
button and then release both the
ton and the switch.
• After the LED light and tightening con-
firmation lamp have illuminated and the
buzzer has rung, the control panel will
flash and change to configuration mode.
NOTE:
• Tools ship from the factory set to the
following mode.
EYFGA1: 0
EYFGA: 75
EYFGA: 45
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.
but-
Display
. Press the
clutch setting that is appropriate for the
work being performed.
As the
is pressed
78
-  -
A
B
C D
EYFA31
Battery indication lamp
and buttons to select the
button As the
is pressed
79 80 15
77 ... 17
OK button
button
16